Panasonic 8-DISC CD CHANGER CX-DP801EUC - Manual (Page 16)

Installation Guide continued
□ Installation Location
Do not install this unit on the rear tray of a car where the internal temperature can rise to high levels. Failure to
comply with these instructions may cause problems. Also avoid installing the unit in the following locations.
• In areas hit by direct sunlight, hot air from the heater, or any other high-temperature location.
• In an area where you cannot firmly secure the unit, or in high-vibration areas.
® In areas with high humidity or high dirt and dust levels.
How to install this unit
Use a screwdriver to set the angle-adjusting hole to the position “V" or “H,” depending on the mounting angle
selected. (When shipped from the factory, the angle-adjusting hole is set to the “H" position as default.)
® When setting vertically: Set to the “V” position,
o When setting horizontally: Set to the “H” position.
Caution
• Set the angle-adjusting hole to the same angle as
selected.
• Set the holes correctly of the left and right sides
without fail.
This unit can be set in the five direc­
tions: horizontai, verticai, and the posi­
tions A (22.5°), B (45°), and C (67. 5°).
Mount the unit by referring to the fig­
ures below.
i/>
-V
Angle-adjusting hole
How to install the unit and select the mounting angle
Installation Angle Selecting a mounting angle
Typical horizontal installation
(Normal) (Up-side down)
О X
Limit to iess than 10 degrees.
......
ШШ
I / ^
-...........
\
\
Ф- V
Limit to iess than 10 degrees.
Set the hoie to the same positions tor
both left and right.
n
u
€
5
Typical vertical installation
(Normal) (Up-side down)
о
X
Do not tiit in this Limit to
direction. Limit less than
to less than to 10 de­
degrees. grees.
^ S \
I
V-
Set the hois to the same positions for
both ieft and right.
16
CX-DP801EUC