Panasonic TC-29V50R - Manual (Page 14)

Tuning Procedure
How to Tune in Your TV Set
(Automatic Search)
1. The TV set must be turned on.
PRE.
2. Press the "PRE." button until the on-screen
display appears as follows :
Programme
Number
{0-59)
Sound System
Colour
System
1
SEARCH V l -
4.5MHz
AUTO
k
— Band
Indicator
V l :VHF Low Sand
V h ;VHF High Band
U ;UHF Band
3. Press the "FUNCTION" button .
The on-screen display appears
as shown:
/— A
1 SEARCH V l
j
Searching
0 SEARCH V l
4.5MHz
AUTO
MONO SURROUND
Completion
The best tuning position is automatically
memorized.
4. Press the "PRE.” button twice to return the
TV set to the normal operating mode.
A maximum of 60 Programme Numbers
(0-59) can be programmed.
Note:
When the colour or sound is not clear is
produced on a Programme Number,
press the “SYSTEM I or 11” Button.
(Refer to page 17)
How to Tune in Your TV Set
( Manuai Search )
1. The TV set must be turned on.
PRE.
2. Press the "PRE." button until the on-screen
display appears as shown in Figure 1.
V A
3. Press either the Programme Number Up
“ a ”
or Down "v" Button, to select the
Programme Number in which you wish to
store the desired broadcast transmission
channel tuning.
01
4. Press either the Level Adjusment Up ” +"
or Down " - ” buttons, the TV station
broadcasting on the next higher or lower
frequency will be automatically tuned and
memorized.
1 SEARCH V l
i
1 SEARCH V l
4.5MHz
AUTO
Searching Completion
If an undesired TV station is received, press
the same button again until the desired TV
station is tuned.
5. Repeat step 3 and 4 to tune all the available
TV stations on the remaining channel.
Ensure that a new programme number is set
(step 2) before tuning the next station.
6. Press the "PRE." button twice to return the
TV set to the normal operating mode.
14