Panasonic KV-SS855D - Manual (Page 19)

Display Panel Instructions
2 Use the ▼ key or the A key to se­
lect the desired print position.
• The printout, by the display shown
above, will print starting 12.4 mm
(approx. 1/2 in.) from the top of the
paper, but this position can also be
changed by the print position setting.
Top of the paper
10 mm
[Approx. “I
¿[13/32 in.J„
00
o
o
124 mm
[Approx .1
Li/2 in J
Top of the
printout
that is set
newly.
For the setting shown on the right,
the " B” position will become the begin­
ning of the printout.
3 Press the enter key.
• To return to the previous LCD setting
(in step 1), press the esc key.
p r i n t p 0 s i t i 0 n
< 1 c h a r > 1 2 4 m m
¡Clearing the warnings
You can clear the following warnings on the display.
Clean Roller : The alarm tells you it is time to check the roller. If it is near 100%, clean the roller.
See "Cleaning the Unit" on page 32.
Replace Roller : The alarm tells you the roller needs to be changed. If it is near 100%, replace the paper
feed roller module and retard roller module.
See "Replacing the Roller Modules" on page 37.
Replace F-Lamp: The alarm tells you the front side scanning lamp needs to be changed. If it is near 100%,
ask your dealer to replace the front side lamp module.
Replace B-Lamp: The alarm tells you the back side scanning lamp needs to be changed. If it is near 100%,
ask your dealer to replace the back side lamp module.
To clear the clean roller
7 Press the menu key until "Clear
Warning" is displayed.
C 1 e a r W a r n i n 9
2 Press the enter key.
C 1 e a n R 0 1 1 e r
2 0 % C 1 e a r = E N T E R
19