Pedestal removal, Adjustments (continued), A(djustment menu signal – Panasonic PANASYNC SL90I TX-D9S55 User Manual

Page 14: Self-test menu (no signal screen)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Adjustments (Continued)

A(djustment menu

Signal

! Use the 3 and B keys to select either the rear panel input terminal port A

{Mini D-Sub type) or Port B (BNC) type.

This displays the input synchronization signal frequency.

Information on the input screen mode {resolution, horizontal and vertical

synchronization frequency) will be displayed on the display monitor. There are
occasions sometimes when some screen modes in use do not display any

resolution. Direct display allows this to be displayed on screen by pressing

the [H key even when the menu screen is not displayed.

Self-Test menu (No Signal screen)

This display indicates that the monitor is operating normally. When one of the following

conditions occurs, press one of the 4 operation keys to call the appropriate display.

N o

S i g n a l

f H — . — k H z
f V

— H z

P o r t ^

- O -

E r r o r

f H 117.0kHz

fV 190.0 Hz

P o r t ^

-0-

No signal {the computer is not connected,

the mains power to the computer is
disconnected or the input connector in

use may be deselected, see Page 13
Signal for instructions.)

The horizontal or vertical sync, signal are
outside of the permitted range (the value of
the horizontal sync, signal will be displayed

in red and the value of the vertical sync,

signal will be displayed in white.)

Pedestal removal

Observe the following instructions if the unit is to be used with the display stand removed.

Repeat this procedure in the reverse order if the display stand is to be reattached.

Lay the screen down onto a soft object (cushion,etc.) to avoid scratching.

Grasp the bottom of the display stand as

indicated in the illustration.

El

Apply pressure with your fingers to the area

shown in the illustration and lift the stand
slightly in an upward direction.
This will release the lock.

□ Once the lock has been

released, remove your fingers

and firmly lift upwards at an
angle.

This will separate the

stand from the main
unit.

□ Place the unit on top of

the computer to be used

or on a tabletop.

Store the display stand in

the box or other receptacle

in which the computer was
purchased.

13

Advertising