Programming the home theater remote – Panasonic CT-36SF24 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming the Home Theater Remote
The remote control can be set to control other manufacturers components, by utilizing the
MODE SELECTION
BUTTONS
for
CABLE, DSS, VCR, RCVR
(a
Receiver
or
Amplifier), CD, LD,
and
AUX
(for
Cassette Players, Second
VCR
or a
DVD.)
Code Known
Use the following procedure for setting up the
remote control using the numerical buttons
when the component’s remote code is known.
rn Determine the brand of the component.
in Identify the code(s) associated with the
brand from the infrared code index (see
following pages). Record all possible
codes.
n Confirm that the component is plugged
in and operating properly, then turn it
OFF.
[4Ì
Press and hold the
^3)
button, then
the button so that both are
pressed at the same time for
15 seconds. All Mode buttons wiil
flash.
Then let go of the buttons.
fSl
Press the appropriate Mode button
for the component. The pressed
button will illuminate steadily. All
other buttons will go out.
m
Code From
Index Sheet
Enter the 3-digit code, by using the
Remote
Control
Keypad
“0”
through ”9” buttons. If a proper
code was entered, the Mode button
will blink twice then go out.
Bvirihe remòte
ITI
Press the button to test the remote. If
the correct code is setup for the
component (in step [Sl)i the component
wiil turn on.
NOTE:
Some brands have multiple codes.
Repeat the procedure using another
listed
code
until
the
component
responds correctly.
Code Unknown
Use the following procedure for setting up the
remote control when the component's remote
access code is not known. This procedure
uses the "sequence method”.
[01
Confirm that the component is plugged
in and operating properly, then turn it
OFF.
m
Press
and
hold
the
button,
then the button so that both
are pressed at №e same time for at
All Mode buttons
will flash.
Then let go of the buttons.
Press the appropriate Mode button
for the device. The pressed button
will illuminate steadily. All other
buttons will go out.
EUR511060A
1
Press the button to step
over to the next code.
Press the button to test the
remote. If the correct code is
sent, the component will turn on.
Once the correct code is found,
press the
button
to store the code.
Repeat from step El above until the
proper component code is found. It
may take several attempts before
the correct code is found.
NOTE:
If an incorrect code is entered, or
when
the
operation
is
not
completed within 30 seconds, the
settings will not change.
Infrared Remote Codes for Specific Components
Helpfut^lnt:, . Write down the code numbers for your components in the space provided below. This
^ williervei^ a hihdy reference whenever you need toreprb^am your remote control.
CABLE
Cable TV Converter Box
□
VCR
Video Cassette Recorder
n
CD
Compact Disc Player
n
DSS
Digital Satellite System
I
RCVR
Receiver or Amplifier
LD I
Laser Disc Player
!
n
n
n
Other Component
Other Component
other Component
1
i
I
I
I
Other Component
II
Other Component
II
Other Component |
- 3 1 -