If the input is rgb1, To add a second monitor via bridge*connection, If the input is rgb2 – Panasonic DT2750MS User Manual
Page 12: Connections for rgb equipment (d-sub input)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1.
Turn off the power switches of the personal computer and/or your monitor if they are now on.
2.
Connect the HD D-sub signal cable* to the personal computer and the monitor as shown in the following
figures {RGB1 input on the rear or RGB2 input on the front).
3.
Connect the audio RCA signal cable {not supplied) to the personal computer if necessary.
4.
If it has not been installed, first connect one end of the power cable to the monitor and then the other end to
the AC outlet**.
5- Turn on the power switches of the monitor and the persona! computer.
If the input is RGB1,
6.
Set the BNC«HD D-sub switch to the “HD D-sub” position, and press RGB1 button on the front control panel
(see page 8).
7.
This completes the single monitor installation using the HD D-sub connectors and supplied HD D-sub signal
cable.
The 75 ohmc^HI-Z selection switch should be set to the left, marked “75 i2”.
Caution:
* Use only the supplied HD D-sub cable.
** If the AC outlet is of the two prong type, please consult with a licensed electrician.
To add a second monitor via bridge*connection
Check that you have set the BNC«HD D-sub switch to the “HD D-sub” position, and press RGB1 button on the
front control panel (see page 8).
8.
Connect a signal cable from the RGB1 output connector of the first monitor to the RGB1 input connector of
the second monitor.
9.
Set the 75 ohm<=>HI-Z selection switch of the first monitor to the right marked “Hl-Z”.
Also, set the 75 ohm^HI-Z selection switch of the second monitor to the left, marked “75 Q”.
10.
This completes the extra monitor installation using the HD D-sub connectors and supplied HD D-sub signal
cable.
If the input is RGB2,
6.
Press RGB2 button on the front control panel (see page
8
).
7,
This completes the single monitor installation using the HD D-sub connectors and supplied HD D-sub signal
cable.
Caution:
* Do not connect a 15 Pin HD D-sub signal cable to the HD D-sub signal input marked “RGB 2”
for bridge-connection. Use only the terminals on rear panel marked “RGB 1”.
** If the AC outlet is of the two prong type, please consult with a licensed electrician.
Note:
You can also connect MAC computer with MAC adaptor. (See page 39.)
Connections for RGB equipment (D-sub input)
11