I 1-1 direct input signal selection, User control with the front buttons, 1 direct input signal selection – Panasonic DT2750MS User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
User control with the front buttons
Inside of front control panel
With the help of the OSD (On Screen Display), source select, picture quality, and audio can be easily adjusted
with just 6 buttons, located inside the front control panel.
I
1-1 Direct input signal selection
After the monitor is turned on, the “On Screen Display” is not visible (no menu). However, selection of a signal
source can be made directly by pressing an input selection button, such as “RGB1”, “AV1”, or “DTV”. When an
input selection button is pressed, the selected input source message appears on the screen as follows:
c
RGB1
^
_______
RGB1 Q]
Press RGB1 button. Then the signal from RGB1 terminal (rear) appears on the
screen and the “RGB1” message is shown on the screen.
RGB2
Press RGB2 button. Then the signal from RGB2 terminals (front) appears on the
screen and the “RGB2” message is shown on the screen.
AVI O
Press AV1 button. Then the signal from AVI input terminals (rear) appears on the
screen and the “AVI” message is shown on the screen.
AV2
Q )
Press AV2 buttor^. Then the signal from AV2 input terminals (front) appears on the
screen and the “AV2” message is shown on the screen.
DTV O
(Component video)
Press DTV button. Then the signal from component video input terminals
(YP
b
P
r
,
rear) appears on the screen and the “DTV” message is shown on the screen.
23