Panasonic TX-29F155A - Manual (Page 6)

(General Operation^
How to switch the power ON or OFF
The TV set must first be switched on at the wall outlet
and at the Power Switch (refer to page 3).
Press this button to turn the TV set ON, from STANDBY
mode.
Press it again to turn the TV set OFF, STANDBY mode.
Power - indicator
STANDBY - Red
POWER ON - Green
5 4 2
Note: It is also possible to turn the TV set on
STANDBY by pressing the “Direct Programme
Number Selection” buttons (0~9) and the
“Programme Number Up” or “Down” button,
either on the set or on the Remote Control.
(TV set) Programme Number Selection
Press the Programme Number Up “A" or Down “v”
button to select the next higher or lower Programme
Number.
©
©
%
Direct Programme Number Selection
(Ch select = Position)
You can select the numbers directly by pressing “0~9”
buttons and the two digit numbers by pressing “Two
Digif and “Programme Number” buttons.
Programme Number 8 .......... ®
Programme Number 12.........© ,©,®
Direct Programme Number Selection
(Ch select = Direct)
You can select the number directly by pressing the
corresponding Programme Number button.
Programme Number 8 .......... ®
Programme Number 36........ ®,®
Programme Number 124...... ®,®,®
Note: When the Skip setting for Programme Number
100 through 125 is on, the channel selection
time will be shortened, and thus you cannot
input three digits at a time.
Volume Adjustment
Press the Volume Up “+” or Down button to increase
or decrease the sound volume level.
TV/AV Mode Selection
Press the “TV/AV” button to select TV, AVI, AV2, AV3,
AV4, input signal modes sequentially.
Remote control:
Press the TV/AV button to display AV1-AV4 at the
bottom of the screen. Each coloured button
corresponds with each input. For example, pressing the
Red button selects AVI.