Only for u. k, Electrical plug information – Panasonic EY7541 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ONLY FOR U. K.

IX.

ELECTRICAL PLUG

INFORMATION

FOR YOUR SAFETY PLEASE READ

THE FOLLOWING TEXT CAREFULLY

This appliance is supplied with a moulded
three pin mains plug for your safety and

convenience.

A 3 amp fuse Is fitted in this plug.

Should the fuse need to be replaced please
ensure that the replacement fuse has a rat­
ing of 3 amp and that it is approved by ASIA

or BSI to BS1362,
Check for the ASIA mark ^ or the BSI
mark ^ on the body of the fuse.
If the plug contains a removable fuse cover

you must ensure that it Is refitted when the
fuse is replaced.

If you lose the fuse cover the plug must

not be used until a replacement cover is

obtained.

Areplacement fuse cover can be purchased

from your local Panasonic Dealer,

IF THE FITTED MOULDED PLUG IS UN­

SUITABLE FORTHE SOCKET OUTLET IN

YOUR HOME THEN THE FUSE SHOULD

BE REMOVED AND THE PLUG CUT OFF

AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE

ELECTRICAL SHOCK IF THE CUT OFF

PLUG IS INSERTED INTO ANY 13 AMP

SOCKET.
If a new plug is to be fitted please observe

the wiring code as shown below.

If in any doubt please consult a qualified

electrician.

IMPORTANT:

The wires in this mains lead are
coloured in accordance with the follow­
ing code:

Blue: Neutral

Brown: Live

As the colours of the wire in the mains lead

of this appliance may not correspond with

the coloured markings identifying the termi­

nais in your plug, proceed as follows.

The wire which is coloured BLUE must be
connected to the terminal in the plug which
is marked with the letter N or coloured

BLACK.

The wire which is coloured BROWN must be
connected to the terminal in the plug which is

marked with the letter L or coloured RED,
Under no circumstances should either of

these wires be connected to the earth ter­

minal of the three pin plug, marked with the

letter E or the Earth Symbol

How to replace the fuse; Open the fuse

compartment with a screwdriver and replace

the fuse and fuse cover if it is removable.

Fuse Cover

This apparatus was produced to BS800.

-

15

-

Advertising