Panasonic RX-E300 - Manual (Page 14)

..
: eaKIWg > : : :: ■.«»
v^S: £ ^; ì - .r^" ■ ■■■■::-!: i;-:
*,
JiS- à ;: 1;
Listening to broadcast stations which
have not been programmed
(Manual tuning)
1 2
F ba ND i
L—J^
ForU.K.:
Press BAND to display “LW”,
“MW” or “FM”.
LW^ M W~> FM---------------------------- 1
c
(The display changes each time the but­
ton is pressed.)
For Australia, New Zealand:
Press BAND to display “FM”
or “AM”.
AM-> FM-------------------------------------- 1
C
(The display changes each time the but­
ton Is pressed.)
■
C )'/(
Ì 1 (
n ~i r n
Li t._iU
,
D<]<1/<J<3 t»/l>i>t]
'^N ing /
“Time SET
Press D<Ki/<i< or E>[>/i>i>a to
tune in the broadcast station.
»/»O : Press this to increase the
broadcast frequency.
CKK!/<K1: Press this to decrease the
broadcast frequency.
FM stations can be selected automati­
cally (see below).
Lights when an FM stereo
program is picked up.
t~ tut
I 1 1
rii Q 1 n
UU. lU
\___________ T 1
Lights when a station is
tuned in properly.
14
Selecting FM stations automatically:
Keep the button depressed until the frequency display starts to
change. A station with good reception is automatically selected and
the selection process then stops.
Frequency display steps:
The frequency display changes in the following steps:
(For U.K.)
FM:
50 kHz steps
LW, MW: 9 kHz steps
(For Australia, New Zealand)
FM; 100 kHz steps
AM: 9 kHz steps
For better reception
ra
STAIOKO
O'
O o
o o
o o
o o
■€5 O
o
o o
o o
G O
o o
o o
o o
o o
o o
o o
o o
G O
G G
When there is too much interference during an
FM stereo broadcast
(Available only from the remote control)
Reduce the interference by setting the sound to monaural.
STy№)N0 Press ST/MONO.
C A// oo ID
1 1 t UU. (U
Knnisit KHma
Lights.
To return to stereo reception, repeat the same procedure and turn
off the incHgi display.
The SI display will not light in the monaural mode even when a
stereo broadcast is received.
Adjusting the antenna for better reception
FM
Puii out the telescopic antenna and adjust its length and angle for
optimum reception.
AM (LW/MW)
Turn the unit in the direction which gives the best results.