Panasonic RX-DT600 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Before requesting service for this unit, check the chart below for a
possible cause of the problem you are experiencing. Some simple
checks or a minor adjustment on your part may eliminate the problem

and restore proper operation.

If you are in doubt about some of the check points, or if the remedies
indicated in the chart do not solve the problem, refer to the directory
of Authorized Service Centers (enclosed with this unit) to locate a
convenient service center, or consult your dealer for instructions.

Problem

Probable cause(s)

Suggested Remedy

Common problems

No operation when unit is
powered by dry batteries.

Is the AC power cord still connected to the unit

while batteries are being used?

Disconnect the AC power cord.

Are the batteries flat?

Replace them with new ones.

Alternatively, use a household AC outlet as the

power source.

Have the batteries been installed incorrectly with
their {+) and (-) polarities reversed?

Align the (+) and (—) polarities correctly.

While listening to CDs

Play does not start.
No display of track
numbers, etc.

Has the CD been installed upside down?

Install the CD with the label side facing up.

Has condensation formed on the unit's CD

section?

Turn the unit on and leave it on for about an hour
before further operation.

Certain sections are not

played properly.

Is the CD dirty?

Wipe it with a soft cloth.

Is the CD scratched?

Replace it with a new CD.

While listening to ta

pes

Tape Is not ejected.

Are the batteries flat?

Replace them with new ones or, alternatively, use a

household AC outlet as the power source and then
perform the operation once again.

No recording.

Have the erase-prevention tabs been removed? Cover the holes with adhesive tape.

High level of noise; poor
sound quality.

Are the heads dirty?

Clean them.

Have the heads been magnetized?

Demagnetize them using a head eraser available

from an audio store.

While listening to the radio

High level of noise;
stations cannot be tuned in
well.

Has the antenna been adjusted properly?

Try changing its direction.

Noise heard during AM
reception.

Are you operating the unit and a TV set at the
same time?

Place the unit at a distance from the TV.

Alternatively, turn off the TV’s power.

19

Advertising