Overview, Installation hardware – Panasonic CQE15EUC User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
□ Overview
This equipment should be installed by a profession
al. However, if you plan to install this unit yourself,
your first step is to decide where to install it. The in
structions in these pages will guide you through the
remaining steps: (Please refer to “WARNING" state
ment above).
• Identify and label the vehicle wires
• Connect the vehicle wires to the wires of the
power connector
• Install the unit in the dash
® Check the operation of the unit
If you do encounter problems, please consult your
nearest professional installer.
CAUTION: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not
attempt to use it in any other system. Doing so
could cause serious damage.
Before you begin installation, look for the following
items included in the packing with your unit.
o Warranty Card....... Fill this out promptly
• MSC (in Canada; Panasonic) Servicenter Di
rectory ....... Keep for future reference in case
the unit needs servicing
« Installation Hardware......... Needed for in-dash
installation
□ Installation Hardware
No.
Item
Diagram
Qty
©
Mounting Collar
1
©
Plain Washer (5 mm(t))
2
©
Spring Washer (5 mm0)
2
©
Hex. Nut (5 mm({i)
©
2
(D
Rear Support Strap
1
®
Hex. Bolt
(5 mm0 X 25 mm)
1
©
Toothed Lock Washer
(5 mmcf))
%
1
Mounting Bolt (5 mmifi)
1
®
Power Connector
1
Unit Case
1
CQ-E15EUC
17