Cq-va70eu – Panasonic CQVA70EU User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting the Side-brake Detection Cord
Note:
Make sure to connect the side-brake cord to ensure safety and prevent accidents.
Out of the two cords coming from the side-brake switch, connect the cord that is normally not earthed on
the chassis (when the side-brake is released.)
Make sure to connect the side-brake cord (blue/yellow) to the wiring of the side-brake switch.
The position of the side-brake switch can differ according to the car model. An example is shown below.
Detailed information is obtainable from the car dealer.
Connecting the Reverse Cord
* Connect the reverse cord (violet/white) to the plus
wire of the backup light. The backup light (with a
clear lens) is located at the rear of the car and lights
when the gear lever is put into reverse (R).
Backup light
REVERSE cord/4m
(violet/white)
Crimp connector
iO=
r ^
Battery
Location o1 backup lamp
' The backpup light wiring can be
reached from the trunk.
CQ-VA70EU
41