Panasonic CF-18 - Manual (Page 24)

List of Error Codes
The following is a list of the messages that BIOS can display. Most of them occur during POST. Some of them display
information about a hardware device, e.g., the amount of memory installed. Others may indicate a problem with a device,
such as the way it has been configured. Following the list arc explanations of the messages and remedies for reported
problems.
If your system displays any of the below error messages other that the ones marked with an asterisk (*), write down the
message and contact Panasonic Technical Support. If your system fails after you make changes in the Setup menus, reset the
computer, enter Setup and install Setup defaults or correct the error.
0200 Failure Fixed Disk
Fixed disk in not working or not configured property. Check to see if fixed disk is attached properly. Run Setup.
Find out if the fixed-disk type is correctly identified.
0211 Keyboard error
Keyboard not working.
0212 Keyboard Controller Failed
Keyboard controller failed test. May require replacing keyboard controller.
0213 Keyboard locked - Unlock key switch
Unlock the system to proceed.
0230 System RAM Failed at offset : nnnn
System RAM failed at offset nnnn of in the 64k block at which the error was detected.
0231 Shadow RAM Failed at offset : nnnn
Shadow RAM failed at offset nnnn of the 64k block at which the error was detected.
0232 Extended RAM Failed at offset : nniw
Extended RAM Failed at address fine : iwnn
Extended memory not working or not configured properly at offset or address line nnnn.
0250 System battery is dead - Replace and run SETUP
The CMOS clock battery indicator shows the battery is dead. Replace the battery and run Setup to reconfigure the system,
*0251 System CMOS checksum bad - Default configuration used
System CMOS has been corrupted or modified incorrectly, perhaps by an application program that changes data stored in CMOS. The
BIOS installed Default SETUP Values. If you do not want these values, enter Setup and enter your own values. If the error persists, check
the system battery or contact Panasonic Technical Support.
0260 System timer error
The timer test failed. Requires repair of system board.
0270 Real time dock error
Real-time clock fails BIOS test. May require board repair.
0271 Check date and time settings
Real-time clock is illegal. Run Setup and set the date and clock.
*0280 Previous boot incomplete - Default configuration used
Previous POST did not complete successfully. POST loads default values and offers to run Setup. If the failure was caused by incorrect
values and they are not corrected, the next boot will likely fail. On systems with control of w ait states, improper Setup settings can also
terminate POST and cause this error on the next boot. Run Setup and verify that the wait-state configuration is correct. This error is cleared
the next time the system is booted.
02D0 System cache error - Cache disabled
Contact your Panasonic Technical Support.
Failing Bits : nnnn
The hex number nnnn is a map of the bits at the RAM address which failed the memory test. Each 1 (one) in the map indicates a failed bit.
See error 230,231 or 232 for offset address of the failure in System, Extended or Shadow memory.
Operating System not found
Operating system cannot be located on either drive A; or drive C:. Enter Setup and see if fixed disk and drive A: are properly identified.
Press <F1> to resume, <F2> to Setup
Displayed affer any recoverable error message. Press <F1> to start the boot process or <F2> to enter a Setup and change the settings. Write
dowm and follow the information shown on the screen.
0614 Serial Port A config. error - device disabled
0616 Serial Port B co nfig. error - device disabled
Serial Device I/O Address or IRQ are in conflict. Change the I/O Address or IRQ in the Setup Utility.
24