STIEBEL ELTRON VERTICAL TILT RACK 45 - Manual (Page 4)

17 West St., W. Hatfi eld, MA 01088
| 800.582.8423 | 413.247.3380 | fax 413.247.3369 | [email protected] | www.stiebel-eltron-usa.com
Simply the Best
INSTALLATION INSTRUCTIONS
VERTICAL TILT RACKS - 45 SIDE-BY-SIDE ORIENTATION
6. Position the mounting frames over the hypotenuse rail
on the triangular racks. Insert the bolt through the hole in
the hypotenuse rail. Loosely thread the nut onto the bolt on
the inside of the U-Channel. Make sure the notches in the
frames face inward.
7. If multiple collectors are being installed, use the frame
connector kit to fasten two frame pieces together. Slide the
bolts into the groove on the short side of the frame piece.
Abut the two frames together, and tighten the bolts over the
frame connector.
3. Remove X-Braces from its box (560106). Fasten the
X-Braces to the racks using and M10 x 20mm bolts & nuts.
4. Use the M6 bolt and nut to secure the two X-Brace
pieces together.
5. Remove the mounting frames from the box. Slide 2
M10 x 20mm bolts into the groove in the long side of the
mounting frame. Do this for each mounting frame.