STIEBEL ELTRON SOL 27 PREMIUM W - Manual (Page 9)

17 West St., W. Hatfi eld, MA 01088
| 800.582.8423 | 413.247.3380 | fax 413.247.3369 | [email protected] | www.stiebel-eltron-usa.com
Simply the Best
INSTALLATION INSTRUCTIONS
SOL 27 PREMIUM S & W COLLECTORS - 230016 & 230017
6. Inulate the connection using the provided thermal
insulation.
Inlet & Outlet Connection
The inlets & outlets are plug-in style connections identical to
the inter-panel connections. The installation method is the
same as the inter-panel connection.
Connector clip
Outlet connector
Inlet connector
1. Insert the inlet/outlet connector into the collector
connection on each end of the array. Make sure to insert the
connection with a sensor well on the end of the array that
you intend to be the hot side (the outlet of fl ow of the array).
2. Fit the connecting clip at the junction between collector
and plug-in connection.
3. Secure the connecting clip by pushing down on the
locking tab.
4. Install the inlet of the collector array in the same
manner.
Collector Sensor
The correct connection of the collector sensor is crucial to
the correct function of the solar system.
1. Secure the sensor lead.
2. Connect the sensor lead to the controller. Be sure
to properly insulate the sensor wire using standard
procedures.
Lightning Protection
If the building has a lightning protection system, the
collector casing, mounting frame and pipework must be
connected to the existing lightning protection scheme.
Connect the collector to the lightning protection system
using screw fi ttings. Use two stainless steel seft-tapping
screws per collector.
1. Pre-drill the holes. Position the drill holes on the lower
part of the front of the collector in the area shaded in the
following illustration. When drilling the holes, maintain a
distance of at least 4 inches from the corner of the collector
casing.