STIEBEL ELTRON GALAXYTM Series Automatic Hand Dryer - Manual (Page 3)

GALAXY with Plastic Housing
Installation Instructions for the
Licensed Installer
DO NOT INSTALL UNIT WHERE IT CAN ACCIDENTALLY BE
SPLASHED WITH WATER, ELECTRIC SHOCK MAY RESULT.
WARNING: BEFORE BEGINNING ANY WORK ON THE ELECTRIC
INSTALLATION, BE SURE THE MAIN BREAKER PANEL SWITCH IS
“OFF” TO AVOID ANY DANGER OF ELECTRIC SHOCK.
NOTE: THE CIRCUIT SHOULD BE EQUIPPED WITH A “GROUND
FAULT INTERRUPTER” WHERE REQUIRED BY LOCAL, STATE OR
NATIONAL ELECTRICAL CODES.
1. All electrical work must comply with national and
applicable state and local electrical codes.
2. The GALAXY TM hand dryer must have its own
independent circuit using 3 wire cable of the appropriate
size protected by a correctly rated double pole circuit
breaker. The GALAXY
TM 1 unit for 110-120V requires a 20
amp circuit breaker and a gauge #12 copper wire. The
GALAXY
TM 2 unit for 220-240V or 208V requires a 15 amp
circuit breaker and a gauge #12 copper wire.
3. Install unit so that the bottom is approximately 48" above
floor. Unit should be at least 4" from a perpendicular wall.
(FIG. 1, previous page)
4. Transfer the four mounting points to the wall by using the
enclosed drilling template and drill mounting holes.
5. Remove the two screws at the air outlet grill and the
screw on the locking bolt (FIG. 2).
6. Pull down locking bolt. Remove front part of housing
(FIG. 2).
7. Install a 1/2" electrical connector in the back part of
housing in the hole located below the wiring block.
8. Feed wires through connector; tighten clamp down on
wire. Mount back part of housing to the wall.
9. The “live” wires must be connected to the slots on the
terminal marked N/L and L. Ground wire must be
connected to the wire terminal on the blower housing with
the ground symbol.
WARNING: AS WITH ANY ELECTRIC APPLIANCE, FAILURE TO
ELECTRICALLY GROUND UNIT MAY RESULT IN SERIOUS INJURY
OR DEATH.
10. Reinstall front cover, push up locking bolt and reinstall
the three screws that were removed earlier.
Technical Data
GALAXY TM 1: 120V, 60 Hertz, 1850 Watts
(Heating element 1800 Watts, motor 50 W)
GALAXY TM 2: At 240V, 60 Hertz, 2000 Watts
(Heating element 1950 Watts, motor 50 W)
At 208V, 60 Hertz, 1500 Watts
(Heating element 1450 Watts, motor 50 W)
For dimensions see figure 3. The weight of the unit without shipping
materials is 5.5 lbs (2.5 kg).
6 7/8"
175 mm
9 1/16" 230 mm
9 7/8"
250 mm
6 7/8" 175 mm
FIG. 2
FIG. 3
TM
1
2
3
1M
~
N/L L
GRD
N/L
L
1 Fan Motor
2 Heating Element
3 Sensor
GRD
208—240V/60Hz
110—120V/60Hz