STIEBEL ELTRON SOL 25 PLUS - Manual (Page 40)

40 | SOL 25 PLUS WWW.STIEBEL-ELTRON-USA.COM
APPENDIX A
SOLAR ROOF MOUNT FLASHING KIT INSTALLATION
Quik F
oot –
Pr
od
uct Gu
ide
877-859-3947 Committed to the Support of Renew
able Energy
© EcoF
asten Solar
® All content protected under copyright.
All rights reserved.
12/30/11
EcoFasten Solar
2.1
Installation Instructions
1.
Locate the r
afters and snap horizontal and vertical lines to mark the installation
position for each Quik F
oot.
2.
Install base as shown using appropriate fasteners
.*
3.
Insert the flashing so the top part is under the next row of shingles
and pushed
far enough up slope to prevent w
ater infiltr
ation through vertical joint in shingles
.
4.
Install bare EPDM w
asher on stud,
pushing it down until it is flush with the top of
the flashing.
5.
Apply compression br
ack
et to stud.
Install bonded w
asher with rubber side down,
and tighten stainless nut to 50 inch-pounds
.
Consult an engineer or go to www
.ecofastensolar
.com for engineering data.
*EcoF
asten recommends XHD fasteners by OMG
.
1
2
3
4
5
X