MagnaFlow JEEP TRUCK COMPASS Stainless Cat-Back System PERFORMANCE EXHAUST - Manual (Page 2)

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1. Begin removal of the OEM exhaust
system by loosening the clamp behind the catalytic
converter
Step 2. Disengage hangers from rubber insulators
and remove the OEM exhaust.
Step 3. Begin installation of your new
MAGNAFLOW system by attaching the Inlet Pipe
Assembly to the catalytic converter outlet using the
2.25" supplied Clamp and OEM insulator. Keep all
fasteners and clamps loose until final adjustment.
Step 6. Once a final position has been chosen for
the new exhaust system, evenly tighten all clamps
from front to rear using the torque specifications on
page one of the instructions. Inspect all fasteners
after 25-50 miles of operation and re-tighten if
necessary.
Step 4. Next use the supplied 2.25" clamp to
attach the Mid-Pipe to the Inlet Pipe.
025
021
008
016
Step 5. Next use the supplied 2.25" clamps to
attach the Muffler Assembly to the Mid Pipe and the
Tail Pipe Assembly to the Muffler. Fit hangers into
rubber insulators.
007
010