MagnaFlow FORD MUSTANG Stainless Cat-Back System PERFORMANCE EXHAUST - Manual (Page 2)

Step 5:
Once a final position has been chosen for
the new system, evenly tighten all fasteners from
front to rear. The supplied band clamps must be
VERY tight to properly align the pipes and prevent
leaks (Approximately 40ft-lbs). U-bolt clamps should
be tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
**MagnaFlow strongly recommends
professional installation, and any
cutting or modification to the valence
or fascia should be conducted at your
own risk.
SHEET 2 OF 2
Fig. 1
Fig. 2
2010 Ford Mustang 4.0L Competition Cat Back System
INSTALLATION INSTRUCTIONS
15078