MagnaFlow FORD TRUCK EXPLORER Stainless Cat-Back System PERFORMANCE EXHAUST - Manual (Page 2)

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1. Begin removing the OEM exhaust by
unbolting the OEM inlet flange at the outlet of the OEM
catalytic converter with a 13mm socket. Remove the
welded hangers from the rubber insulators using a pry
bar. Do not discard or damage the insulators or the
flange fasteners as they will be needed to install your
new system. The OEM system may now be removed.
Step 3. Next slip the Resonator Assembly inlet pipe
on to the outlet of the Inlet Pipe Assembly and loosely
secure using the supplied 2.25" clamp and 15mm
socket. Engage welded hanger to the OEM rubber
insulator.
Step 2. You are now ready to install your new
MAGNAFLOW system. Attach the the Inlet Pipe
Assembly to the OEM catalytic converter outlet using
the OEM hardware. Engage the welded hanger to the
OEM rubber insulator (Leave all clamps and hardware
loose for final adjustment of the complete system).
Step 4. Slip the inlet of the Y-Pipe Assembly over the
outlet of the Resonator Assembly and loosely secure
using the supplied 2.50" clamp and 15mm socket.
Engage all welded hangers to the OEM rubber
insulators. Install the Muffler Assemblies using a
similar procedure.
155
135
129
128
Step 5. Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear using the torque specifications on page one of this
document. Inspect all fasteners after 25-50 miles of
operation and retighten if necessary.
126