MagnaFlow FORD TRUCK F-150 Stainless Cat-Back System PERFORMANCE EXHAUST - Manual (Page 2)

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1. To remove the OEM exhaust system, you
will to need to cut the pipe beind the muffler before it
goes over the axle. You can then disengage the
welded hangers from the OEM rubber insulators
and remove the tailpipe
. Unbole the flange attaching
the OEM Resonator to the catalytic converter. Do
not damage or discard the OEM fasteners or rubber
insulators, as they will be reused to mount the new
system. Disengage the muffler hangers and remove
the OEM exhaust from the vehicle
.
Step 2. Begin by fastening the Resonator
Assembly to
the catalytic converter using the supplied 10mm
nuts, the OEM clamp assembly and by fitting the
welded hanger into the OEM rubber insulator(Leave
all clamps and fasteners loose for final adjustment
of the complete system.) Install the Muffler to the
Resonator Assembly using the supplied 3.00"
clamp. Next install the Tailpipe Extensions to the
Muffler in the similar fashion using the supplied
2.50" clamps.
Step 3. Next you will need to use the supplied
U-Clip nut and attach them to the recieving cut outs
in the bottom of the frame member. Fasten the
supplied hanger assemblies to the frame members
using the supplied bolts on both the Driver and
Passenger side. Then install the Tail Pipe
Assemblies to the Tail Pipe Extensions using the
supplied 2.50" clamp, fitting the welded hangers into
rubber insulators.