MagnaFlow FORD TRUCK BRONCO Stainless Crossmember-Back System PERFORMANCE EXHAUST - Manual (Page 2)

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1. After removal of the OEM system you can
begin installation of the Magnaflow system. Start by
attaching the X-Pipe Assembly to the factory outlets
using the supplied 2.50" clamps. Leave all clamps
and fasteners loose until final adjustment.
Step 2. Next install the mufflers as shown (be
aware of orientation) using the supplied 2.50"
clamps.
Step 3. Before installing the Tail Pipe Assemblies
you will need to install the supplied threaded
hangers into holes in the frame rails behind the rear
differential using two supplied nuts and washers to
adjust height and lock into place.
Step 4. Install Tailpipe Assemblies using supplied
2.50" clamps. Fit hangers onto installed hangers
using the supplied black rubber insulators. Fit
hanger brackets to existing threaded holes in the
frame rails using the supplied blue grommets and
fasteners.