Casablanca Fan Company Stealth 3243Z - Manual (Page 6)

6
Step 4. To hang the fan body in the canopy, support the
fan at the center of the glass holder and top support and
insert the ball into the canopy opening. Rotate the fan
body until the slot in the ball fits into the pin opposite the
canopy opening.
HANGING FAN BODY IN CANOPY
BLADE
HOLDER
BLADE
TIP
BLADE
ATTACHING THE BLADES
BALL
SLOT
PIN
GLASS
HOLDER
INSIDE
TOP SUPPORT
Step 3a. Attach the 5 blade tips to the blades using two
6-32x 1 ⁄
8
” round head screws provided. Note: the screws
have locktite on them, so once they are installed it will
be difficult to remove the screws.
Step 3b. attach each of the five blades to the blade
holders using four of the truss head screws and fiber
washers provided for each blade. The truss head screw
is placed through the blade and then a fiber washer is
pressed on so that it is between the blade and blade
holder; see the detail drawing below. Hand tighten each
truss head screw firmly.
CANOPY ELECTRICAL CONNECTORS
wHITE wIRES
(2)
BLACk wIRES
(2)
GREEN wIRES
(3)
wIRE NUT
Step 5. attach the fan wires to the ceiling fixture outlet
box wiring by twisting the bare ends of the wires together
and securing with a wire nut. Connect in this order:
• GreeN leads from mounting plate and fan to
GrOUND conductor of power source. secure with
wire nut.
• WHITe wire from fan to white NeUTraL wire in ceiling
fixture outlet box. secure with wire nut.
• BLaCK wire from fan to black (or red) pOWer wire
in ceiling fixture outlet box. secure with wire nut.
Note: Write down the
Serial Number and
the model number for
future reference.
3b - BLADE INSTALLATION:
BLADE
BLADE TIP
6-32x 1 ⁄
8
”
ROUND
HEAD
SCREw
BLADE
BLADE TIP
6-32x 1 ⁄
8
”
ROUND HEAD
SCREw
3a - BLADE TIP INSTALLATION:
TRUSS HEAD
BLADEHOLDER
SCREw
BLADE
BLADE-
HOLDER
FIBER
wASHER
Note: Fan Weight is 33 lbs.