MagnaFlow TOYOTA TRUCK TACOMA Stainless Cat-Back System PERFORMANCE EXHAUST User Manual
Page 2
MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1.
Begin removal of the OEM exhaust
system by unbolting the two spring loaded bolts
attaching the exhaust to the catalytic converter. Do
not discard or damage the OEM fasteners or rubber
insulators as they will be used to install the new
system.
Step 2.
Disengage hangers from rubber insulators
and remove the OEM exhaust.
Step 3.
Begin installation of your new
MAGNAFLOW system by attaching the Inlet Pipe
Assembly to the catalytic converter outlet using the
OEM fasteners and insulator. Keep all fasteners and
clamps loose until final adjustment.
Step 5.
Once a final position has been chosen for
the new exhaust system, evenly tighten all clamps
from front to rear using the torque specifications on
page one of the instructions. Inspect all fasteners
after 25-50 miles of operation and re-tighten if
necessary.
Step 4.
Next use the supplied 2.50" clamps to
attach the Muffler Assembly to the Inlet Pipe and the
Tailpipe Assembly to the Muffler Assembly.
Complete by fitting the hangers on the Tailpipe into
the insulators.