MagnaFlow GMC DIESEL DURAMAX, 5in. SYSTEM Aluminized Pro Series Diesel PERFORMANCE EXHAUST User Manual
Page 2
MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1.
To begin the removal of the OEM system
you will need to cut 18.25" behind the DPF. You can
then disengage the welded hangers from the rubber
insulators, working rearward finish removing the
system. Do not damage or discard the rubber
insulators, as they will be reused to mount the new
system
.
Step 3.
Next Install the Tail Pipe Assembly in a
similar fashion using the supplied 5.00" clamps and
by fitting the welded hangers into the rubber
insulators.
Step 2.
Begin installation of the Magnaflow system
by first clamping the 4"-5" Adapter Nipple to the
newly cut outlet of the DPF using a supplied 4.00"
clamp. Then attached the Over Axel Assy to the
Adapter Nipple using the supplied 5" clamp and
fitting the hangers in the rubber insulators (leave all
clamps loose for final adjustment of the complete
system).
Step 4.
Once a final position has been chosen for
the new exhaust system, evenly tighten all clamps
from front to rear using the torque specifications on
page one of the instructions. Inspect all fasteners
after 25-50 miles of operation and re-tighten if
necessary.