MagnaFlow FORD DIESEL 6.0L DIESEL, 4in. AL Custom Build Pipe Kit Diesel PERF. EXHAUST User Manual

Page 2

Advertising
background image

Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)

Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The welded band clamp must be VERY tight to
properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.





Mufflers, Converters,

Systems and Tips

INSTALLATION INSTRUCTIONS

18991

2003-2007 Ford F-Series - 6.0L V8 Crew Cab

Long/Short Bed

Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.

** Magnaflow Performance Exhaust recommends professional
installation on all their products

Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688

Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500

Nov 21, 2012
Rev: 000

Fig. 1

Fig. 2

UPPER BOLT

LOWER BOLT

Advertising