Analogue Solutions Nyborg - Manual (Page 25)

2 Voice Mode/Poly Chain
Nyborg has modified software to add poly-chain to accommodate one other synth.
This will allow 2 Nyborgs to be played together as a single 2 voice polysynth. (4 voice
is possible too on request - if you are lucky enough to own 4 Nyborgs, but you will
need some new software).
TO CONNECT THEM UP:
•
Set the Slave Nyborg to MIDI channel 2
• Plug your MIDI keyboard to the MIDI In of the Master Nyborg
• Connect the MIDI Thru from the Master Nyborg to the MIDI In of the Slave
Nyborg
• To activate the Poly mode, Press and hold the FUNC button whilst powering up
the Master Nyborg. (Do the same to toggle it back to normal mono mode). Poly
/ Mono mode is remembered in non-volatile memory.
• There is no need for the Slave Nyborg to have the special software or be in any
special mode, just as long as it is set to Channel 2
Note; Pitch bend is not passed through. The poly mod is fairly basic (for example
there is no note buffer) but it suffices as a 'free' extra and works well enough!
If you are using a single Nyborg and you find it acting a little strange, it could be that
it is in poly mode, in which case, toggle it back to mono mode.