Analogue Solutions Nyborg - Manual (Page 27)

Troubleshooting
NO SIGNAL
• Your mixing desk / monitoring equipment is on and working correctly.
• Check the synth is switched on and that the power adaptor is functioning
correctly.
• Check it is connected to your monitoring equipment correctly and that the cable
is not faulty.
• Ensure the output volume is high enough.
• Ensure the mixer level controls are turned to some sound source like the VCOs
or Noise.
• Certain extreme filter settings may filter out all of the signal or produce low level
signals. Try adjusting the filter cut-off.
• Certain extreme PW/PWM settings may cause the pulse outputs to cut-out. Try
adjusting PW/PWM as necessary.
• Try putting the VCA to BYPASS to hear the raw sound, but if you are using a
MIDI keyboard to trigger the envelopes and VCA, ensure correct MIDI
connection, and that the correct channels have been selected.