Cisco H.323 VC-289 - Manual (Page 40)

Configuring H.323 Gatekeepers and Proxies
H.323 Gatekeeper Configuration Task List
VC-328
Cisco IOS Voice, Video, and Fax Configuration Guide
Step 4 Router(config)# destination-info {e164 | email-id
| h323-id} value
Configures a trigger that is based on a particular
destination. Repeat this command for more destinations.
The keywords and arguments are as follows:
• e164—Indicates that the destination address is an
E.164 address.
• email-id—Indicates that the destination address is an
e-mail ID.
• h323-id—Indicates that the destination address is an
H.323 ID.
• value—Specifies the value against which to compare
the destination address in the RAS messages. For
E.164 addresses, the following wildcards can be
used:
– A trailing series of periods, each of which
represents a single character.
– A trailing asterisk, which represents one or more
characters.
Step 5 Router(config)# redirect-reason value Configures a trigger that is based on a specific redirect
reason. Repeat this command for more destinations. The
value argument specifies the value against which to
compare the redirect reason in the RAS messages.
Possible values are from 0 to 65,535. Currently used
redirect reasons are as follows:
• 0—Unknown reason.
• 1—Call forwarding is busy or called DTE is busy.
• 2—Call forwarded; no reply.
• 4—Call deflection.
• 9—Called DTE out of order.
• 10—Call forwarding by the call DTE 15—Call
forwarding unconditionally.
• 15—Call forwarding unconditionally.
Command Purpose