Function button, Clear a-net resources, Password lock – Aviom 6416dio User Manual
Page 66: Clear a‑net resources password lock
56
A
dvANced
F
uNctioNs
Function Button
The Function button is used in combination with other front‑panel buttons
to access features of the user interface such as setting/changing the module’s
password, network‑wide password protection, and other Control Master
settings. Functions are mapped to the channel activation buttons; the exact
labeling of the buttons is determined by the I/O configuration of the module
(8‑channel versus 16‑channel, etc.).
To access the advanced functions, press the
F
unCtion
button; its button LED will
light. Next, press the channel button (or button combination) that corresponds
to the desired function, followed by the
E
ntEr
button to activate it.
To exit without selecting a Function, press the
C
anCEl
button. Pressing any
front‑panel button other than a channel activation button after the Function
button will also cancel the Function request.
Clear A-Net Resources
This function clears currently active audio channels, stereo links, and VDC
assignments on a module for the current network mode, Auto or Manual.
The module must be unlocked to use this feature. The network cannot be in
Managed Mode.
To clear A‑Net resources, press the
F
unCtion
button. The Function button
and Enter/Cancel LEDs will flash. Press the
ChannEl
1 a
CtivE
button; the VDC
port assignment list and all currently active channels flash. Press
E
ntEr
. The
A‑Net resources are cleared.
To exit without clearing the current A‑Net resources in use, press the
C
anCEl
button.
Password Lock
Every Pro64 network can be password protected. Each module in the
network stores a unique password which can be used to lock the network
when that module is set to be the network Control Master. The current four‑
digit password is required to complete the operation. (On an initialized Pro64
unit, the default password is set to “1‑1‑1‑1.”)
To lock the network:
Press the
1.
F
unCtion
button on the Control Master module.
Press the
2.
ChannEl
9 a
CtivE
button followed by
E
ntEr
.
All channel Active buttons will flash twice and the Enter/
3.
Cancel LED will start to flash.
Enter the current four‑digit network password.
4.
Press
5.
E
ntEr
to complete the operation.
A special LED sequence is displayed in the Signal Present
6.
LEDs to confirm that the network is being locked.