Brookfield Bath, Model TC-101 - Manual (Page 8)

9
Section 3. Programmable Controller
Check for adequate fluid level in the bath and that aft connections are secure.
When first plugged in, before power is turned on, display will read . . . . . . . . . . . . . . .
Press power
Unit will perform self test and read the firmware’s revision level . . . . . . . . . . . . . . . . . .
“Fluid = “ is the current bath temperature
“Set = “ is your temperature setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Notes:
1. After 10 seconds of keypad inactivity, display reverts back to temperature reading.
2. If an error is made in setting values, pressing (escape) allows you to backspace
in order to correct the previously entered values. Repetitive backspacing will return unit to
normal operating display.
3. All entered values are stored in permanent non-volatile memory.
4. To revert back to factory default settings, see section 7.7 Default Settings
5. For negative numbers, press for the minus sign.
3.1 To Set Temperature
Press Enter the operating temperature. Each value is entered on the display from
right to left.
Example: For a desired temperature of 45.0°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Press then then then
then to accept values. (Values are also accepted after 10 seconds of keypad
inactivity.)
COPYRIGHT 1995
SELF TEST VJ BB08
STANDBY
– – – – – – –
FLUID = 20.0
SET = 30.0
PARAMETERS-AT-A-GLANCE
Contrast
Limits
Readout
Ext Probe
Program
Tuning
°U Cal
RS 232
Auto Refrig
FLUID = XX.XX°C
SET = 000.4°C
FLUID = XX.XX°C
SET = 004.5°C
FLUID = XX.XX°C
SET = 045.0°C