Checkline Series-5I - Manual (Page 26)

Model 5i Digital Force / Torque Indicator User’s Guide
25
12. Any errors are reported by the following screens:
Displayed at the start of calibration if a disallowed unit is selected.
Ensure that the load is not swinging, oscillating, or vibrating in any manner. Then try again.
The calibration weight does not match the set value.
The entered calibration point is too close to the previous point.
11 PASSWORDS
Two separate passwords may be set to control access to the Calibration section and to the menu and
other keys. To access the passwords setup screen, select Passwords from the menu. The display will
appear as follows:
PASSWORDS
Calibration
Menu Key
Units Key
Mode Key
Zero Key
Data Key
CALIBRATION
TENSION
LOAD TOO CLOSE
TO PREVIOUS
PLEASE TRY AGAIN
LOAD NOT STABLE
PLEASE TRY AGAIN
CALIBRATION
Units must be gF.
PLEASE TRY AGAIN
PRESS ENTER
CALIBRATION
COMPRESSION
LOAD TOO LOW
PLEASE TRY AGAIN