Checkline ESM - Manual (Page 4)

Models ESM & ES30
3
SAFETY TIPS
•
Wear eye and face protection when testing. Although the ESM has
relatively slow moving mechanisms, be aware of the dangers
posed by potential energies that can accumulate in the sample
during testing.
•
Keep away from the moving parts of the test stand.
•
Never operate the test stand if there is any visible damage to the
power cord or the control unit. The ESM is powered by 110/220
volts that are present in both the power cord and the control unit.
Any contact with this high voltage can cause serious injury or even
death.
•
Ensure that the control unit be kept away from water or any other
electrically conductive liquids at all times.
•
Make sure the electrical outlet powering the test stand has local
earth ground (3-hole outlet).
•
If it is necessary to remove the cover of the control unit or motor
drive, always disconnect power before doing so. Use Mark-10 re-
placement parts, only, if any repairs are needed.
SETUP
Place the stand on a clean, flat and level work area that meets the cri-
teria outlined in the work area safety instructions. For accurate read-
ings, the area should be free of vibrations.
If desired, the stand can be mounted to the work area with two 5/16
screws. Included is a mounting hole drill template for quick setup. Be-
fore the stand can be mounted, the belt cover surrounding the fine ad-
justment knob on the right hand side of the stand has to be removed.
Using a flat screwdriver, loosen the four captive screws and slide off
the cover.
After the two 5/16 screws holding the stand are tight, place the belt
cover back into place. While making sure that there is no contact with
the fine adjustment knob, tighten the screws in the four corners.
ESM
User’s Guide
8
ES30
DIMENSIONS
SPECIFICATIONS
Load capacity 200 lbs. (1000 N)
Maximum travel 13” (228.6 mm)
Loading method Hand wheel
Travel rate 0.05”/rev. (1.27 mm)
Weight (test stand, only) 17 lbs (7.7 kg)
in [mm]