COP-USA USBDVR04SP - Manual (Page 47)

MAXDVR & DR Series Cards 47
Alarm Output
Fig4.15 Alarm output Configuration
[Video Loss]: Users can select alarm output for this option. For example,
users select alarm_out1 and alarm_out3 and remote alarm for video loss.
Then video loss of any channel will trigger alarm_out1, alarm_out3 to show red
light in the Alarm output status panel (refer to Fig3.6 for reference), and the
system will give out related warning message to the terminals in List of alarm
output LAN terminals (refer to Fig 4.12)
[Disk Alarm]: when HDD available space is less than the set value (refer
to Fig4.9), it will trigger selected alarms.
[Sensor 1]: If users have mounted sensors, when the sensors have
been activated, then it will trigger the selected output alarms.
[Sensor 2] – [sensor 16] DR3004F card has maximum 4 sensors, and
DR3016F and DR3116 card have maximum 16 sensors.
[Motion 1]: Users can set motion detection alarm output by different
alarms and remote alarm.
[Motion 2] - [Motion 16] 4CH card has maximum 4 motion alarms, 8CH