Cub Cadet CC 22 - Manual (Page 16)

12
Wheels and Axle
To remove the wheels and axle:
1. Remove the screw and washer that secures the
wheel, using a 7/16” wrench. See Figure 19.
NOTE: If the axle is being removed, the left wheel
must be removed.
NOTE: There is a stop welded to the axle where it
passes through the right hand side of the
trimmer base. This stop will not allow the
axle to slide or rotate. See Figure 20.
2. Remove the spacer and wave washer between the
left hand side wheel and the trimmer base. See Fig-
ure 21.
3. Slide the axle and wheel to the right.
Figure 19
axle bolt
and
washer
Figure 20
axle stop and
hole in frame
Figure 21
spacer
wave washer