Cub Cadet MMZ Rider - Manual (Page 36)

Cub Cadet Commercial M60 Tank - 2002 and prior years
32
11. Loosen both hex jam nuts securing the hydro-
static connecting rod in position using a 1/2"
wrench and channel locks.
12. Start the unit.
13. Rotate the connecting rod clockwise or counter-
clockwise until all rear wheel motion has been
eliminated.
CAUTION: The unit will be running during this
procedure.
14. Shut the unit off.
15. Tighten both hex jam nuts using a 1/2" wrench
and channel locks.
16. Raise the seat and install the wiring harness con-
nector to the seat safety switch. See Figure 6.
17. Remove the 1/4" by 28” alignment dowel rod.
See Figure 7.
18. Install the right rear wheel assembly and secure
it to the axle hub with four lug nuts removed ear-
lier using a 3/4" socket.
19. Lower the unit to the ground.
20. Test the unit and make certain it remains in neu-
tral.
Figure 6
Wiring Harness
Connector
Seat Safety Switch
Figure 7
1/4” by 28” Dowel Rod