Cub cadet commercial m60 tank, Pto belt removal, Service manual – Cub Cadet MMZ Rider User Manual
Page 5
Cub Cadet Commercial M60 Tank - 2002 and prior years
1
PTO Belt Removal
1.
Pivot the seat assembly forward.
2.
Remove the lock nut and hex bolt securing the
negative battery cable to the negative battery ter-
minal using a 7/16” socket and a 7/16” wrench.
3.
Remove the sparkplug wires from the sparkplugs
on the engine.
4.
Lower the cutting deck to the lowest position.
5.
Grasp the floor panel assembly and raise it to the
fully open position.
6.
Unlatch the PTO belt release lever and slowly
pivot it away from the unit. See Figure 1.
Figure 1
Release Lever
7.
Grasp the idler pulley and pull outward while roll-
ing the PTO belt off. See Figure 2.
8.
Roll the PTO belt off of the upper portion of the
double stack pulley. See Figure 3.
Figure 2
PTO Belt
Pull Outward
Idler Pulley
Figure 3
Double Stack Pulley
PTO Belt
Service Manual
Cub Cadet Commercial M60 Tank -
2002 and prior years