Cub Cadet 5000 Series - Manual (Page 78)

Domestic Compact Dash and Steering Pump
62
1.20. Carefully lift the dash panel and remove it from
the tractor. Confirm that the wiring harness and
control cables do not snag as they pull out with
the dash panel. See Figure 1.20.
1.21. Dash panel installation is essenitally the the
reverse of the removal process. The following
tips may ease the installation:
1.22. Route the control cables as the dash panel is
lowered into place. The throttle cable passes
through the grommeted hole at the top right cor-
ner of the lower heat shield. See Figure 1.22.
1.23. The choke cable on gasoline engined tractors
passes through the large opening in the pedes-
tal, below and to the left of the steering column
bracket. See Figure 1.23.
1.24. The choke cable then passes through the grom-
meted hole at the lower right corner of the lower
heat shield. See Figure 1.24.
1.25. Lower the dash panel into positon, so that the
slotted holes flanking the instrument panel slip
over the bolts between the heavy flat washers
and the pedestal.
1.26. Confirm that the lower rear cornerof the dash
panel has cleared the brake pedal.
1.27. Confirm that the lower right mounting point has
cleared the fuse and relay center.
Figure 1.20
1 Up
2 Back
Figure 1.22
Throttle cable
Figure 1.23
Choke cable
Figure 1.24
Choke cable
Throttle cable