Cisco 3032 User Manual
Page 27
27
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
OL-14317-01
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Getting Started Guide
Connecting to the Switch Ports
Installing and Connecting to Devices in the 10-Gigabit
Ethernet Slots
The switch 10-Gigabit Ethernet module slots are used for connections to other
switches and routers. The module slots operate in full-duplex mode and use the
hot-swappable Cisco X2 transceiver modules and the Cisco TwinGig Converter
Module. The X2 transceiver modules have SC connectors to connect to multimode
fiber (MMF) and single-mode fiber (SMF) cables. The Cisco converter modules
have two SFP-module slots that convert the 10-Gigabit interface into a dual SFP
module interface.
shows how to install an X2 transceiver module into the 10-Gigabit port.
Figure 9
Installing an X2 Transceiver Module
Use only Cisco X2 transceiver modules, Cisco converter modules, and Cisco SFP
modules with the switch. Each Cisco module has an internal serial EEPROM that
is encoded with security information. This encoding provides a way for Cisco to
identify and validate that the module meets the requirements for the switch.
250309
STK
B
A
17X
18X
19X
20X
X2-1
21
22
X2-2
23
24