Cub Cadet T2-HP - Manual (Page 39)

T2 ® 35
figure 29, screw tightening sequence
Starting with the number “1” screw location, tighten sequentially through to “10.”
Torque each screw to 105 – 155 lb-in (11 .8 – 17 .5 Nm) .
NOTE: As a general rule, use the low end of
the torque specification.
sIde HOusInG – sCrew TIGHTenInG seQuenCe
10 bolt Housing
14 bolt Housing
11
12
13
14