EKLIPES EKLIPE Black Classic Cobra Ultimate Motorcycle USB Charging System User Manual

EKLIPES Power suppliers

Advertising
background image


The enclosed package you have received has a Cobra EK1-110, 110B, or 110BC unit with a 4ft 6 inch
Wire attached to the unit with a SAE plug, a Mount with 2 mount insert rings that fit 7/8 and 1 inch
handlebars and fits 1 ¼ inch handlebars without the insert rings.

This package also contains a EK1-153 2000 EZ Jump-Start Battery Harness, which is the electrical
wiring harness that makes your EKLIPES System work.

Now, Pay attention because this is the important part. This harness has 2 electrical plugs. One plug is
a SAE Plug with an inline 15 amp fuse link to protect all your electronic devices and the other plug is a
Dims 12 gauge female BMW Jumper Plug which does not have an inline fuse link, so make sure you
test the Dims Female BMW plug as seen in the picture below continuously during your installation.

1)

Check BMW Plug before installation to the battery to make sure Electrical connectors are
securely connected on the Plug before you attach eyelets Red and Black to Battery Terminals to
prevent shock.


To Check and inspect female BMW Plug connectors slide back external housing on harness down wires
towards the Fuse link to make room to unscrew BMW plug housing to check connectors as seen in
pictures 1, 2, & 3 Below. Note! Make sure Both Connectors (Red and Black) are securely connected to
their mini plugs (as seen below) inside the female BMW Plug and are securely tight.

Make sure the positive and negative connectors inside the plug as seen in the picture above are securely
tight before you attach the ring terminals of the harness to the battery terminals as this part should be
last after making sure you have not damaged the plug.

During installation you must be careful as to not pull on the Female BMW Plug when you are feeding
the wiring harness from your battery to snub out to the side of your Motorcycle as seen in the picture
below.

Advertising