Elektron Analog Four - Manual (Page 33)

KITS AND SOUNDS
25
• LEGATO activates portamento for overlapping notes only. LEGATO MODE needs to
be activated for this setting to function.
VELOCITY TO VOL selects how MIDI velocity will affect volume when playing the Sound from
a MIDI keyboard.
• OFF means velocity will not affect the volume of the Sound.
• LOG will apply a logarithmic velocity curve. The volume difference will be greater
between softer keyboard presses than between harder.
• LIN will apply a linear velocity curve. The volume difference between keyboard
presses will correspond linearly to the force applied.
• EXP will apply a exponential velocity curve. The volume difference will be greater
between harder keyboard presses than between softer.
VELOCITY MOD gives access to a menu where up to 5 PARAMETER page parameters can
be assigned to the velocity parameter. Both the VEL parameter of the NOTE menu and the
velocity of incoming MIDI notes sent to the Analog Four from external devices will affect the
assigned parameters. Open the menu by pressing [YES/SAVE]. Setting up the parameters
works in the same way as setting up performance macros, covered on page 16.
PITCH BEND gives access to a menu where up to 5 PARAMETER page parameters can be
assigned to the MIDI pitch bend command. If MIDI pitch bend messages are sent to the
Analog Four from an external device, these messages will affect the parameters assigned in
this menu. Open the menu by pressing [YES/SAVE]. Setting up the parameters works in the
same way as setting up performance macros, covered on page 16.
MODULATION WHEEL gives access to a menu where up to 5 PARAMETER page parame-
ters can be assigned to the MIDI mod wheel command (CC #1). Open the menu by pressing
[YES/SAVE]. Setting up the parameters works in the same way as setting up performance
macros, covered on page 16.
BREATH CONTROLLER gives access to a menu where up to 5 PARAMETER page parame-
ters can be assigned to the MIDI breath controller command (CC #2). Open the menu by
pressing [YES/SAVE]. Setting up the parameters works in the same way as setting up perfor-
mance macros, covered on page 16.
AFTERTOUCH gives access to a menu where up to 5 PARAMETER page parameters can be
assigned to the MIDI after touch command. Open the menu by pressing [YES/SAVE]. Setting
up the parameters works in the same way as setting up performance macros, covered on
page 16.
• Copy, clear and paste operations are available in the LOAD TRACK SOUND and SAVE TRACK
SOUND menus.
• Press and turn the LEVEL knob to increase scrolling speed in the LOAD TRACK SOUND and
SAVE TRACK SOUND menus.
• When in the LOAD TRACK SOUND and SAVE TRACK SOUND menus, Sounds being Sound locked
are indicated by a little sequencer step icon at the end of the name of the Sound. Be careful over-
writing a locked Sound, as it will change the sound of the pattern containing the Sound lock. Read
more about Sound locks on page 37.