Elektron Machinedrum - Manual (Page 12)

USER INTERFACE AND CONNECTORS
4
USER INTERFACE AND CONNECTORS
FRONT PANEL
The Machinedrum front panel:
1. Master volume control. Sets the volume for the main output and headphone jack.
2. The <SOUND SELECTION> LEDs. Used for indicating the current track in focus and for
showing which tracks are triggered.
3. [CLASSIC/EXTENDED] mode change key. Changes current editing mode between
CLASSIC and EXTENDED.
4. SOUND SELECTION wheel. Selects tracks and changes values during editing. You can
also select tracks by holding the [FUNCTION] key while pressing the corresponding
[TRIG] key. It is also used when scrolling in lists.
5. [FUNCTION] key. Press and hold it for accessing the secondary function of another key.
6. [BANK] key. Used for switching between bank group A to D and E to H.
7. [A/E] key. Hold this key while pressing one of the [TRIG] keys to select a pattern in
either the A or the E bank, depending on which bank group is selected. The secondary
function is track muting.
8. [B/F] key. Hold this key while pressing one of the [TRIG] keys to select a pattern in
either the B or the F bank, depending on which bank group is selected. The secondary
function is accent pattern editing.
9. [C/G] key. Hold this key while pressing one of the [TRIG] keys to select a pattern in
either the C or the G bank, depending on which bank group is selected. The secondary
function is the pattern swing settings.
10. [D/H] key. Hold this key while pressing one of the [TRIG] keys to select a pattern in
either the D or the H bank, depending on which bank group is selected. The secondary
function is slide pattern editing.
11. The LCD graphical interface.
12. [ENTER/YES] key. Used for entering sub-menus and for confirming choices.
' &*
&."'& &) &'"&(
&,
&-
'*
')
,"&%
)
+
(
&
*
''
'(
&&
3 HT 4 MT 6 CP 7 RS 8 CB 10 OH 11 RC 12 CC 14 M2 15 M3 16 M4
1/64
1:4 2:4 3:4 4:4
5 LT 9 CH 13 M1
SONG SETUP GLOBAL