Flylink Full HD G-sensor GPS - Manual (Page 7)

- 7 -
Auto LCD off Time: set the time auto turn off the LCD screen; press any key to wake up
the LCD screen.
Reset system: to set the system parameter as the default value.
Night Mode: if the light is dim, night mode can significantly improve the ability to capture
the light, enhancing effect of night photography. Anti-glare function will clear the visual
quality of the files at the night mode.
Light source frequency: to choose the frequency of electric wire, in the event of selecting
the wrong frequency, the horizontal lines interruption will show on the image.
G-sensor: G-Sensor is used to test if the car has any crash. If so, it will automatically lock
the file, there will be a at the right conner of file. In this case, the video won’t be
erased by loop recording. There is eight settings of these sensitivity of the G-sensor:
off/1/2/3/4/5/6/7. “Off” closes the G-sensor function. “1” is the lowest sensitivity and “7” is
the highest. (To prevent too many locked files in the card which may affect normal loop
recording, the max total size of the locked file is 1G)
Manual Lock and unlock the file:
1) During recording, press “mode” to lock the file, and press “mode” again to unlock the file
2) During thumbnail status, short press “power” to lock and unlock the file.
Version: to check the version number of video recorder.
‹
Remarks：
(1) Photo resolution default 5M
(2) In connection with car charger, the car is turned off, make video delay 30 seconds before
shutdown.
Operation