FRITSCH PULVERISETTE 13 classic line - Manual (Page 18)

CAUTION!
The weight of the disk mill is approx. 160 kg with grinding
disks.
NOTICE!
Place the disk mill on a flat, stable surface. It may be
screwed to this or a base plate.
1. The disk mill is screwed to the transport palette from below using
3 screws. Loosen the screws with a spanner (17 mm).
2. Lash the harness to a crane or another hoist.
3. Next lash the harness to the eyelets.
4. Using the crane, bring the disk mill to the desired position. When
positioning the device, make sure it does not swing when it is sus-
pended from the crane.
5. Remove the harness.
4.4 Ambient conditions
WARNING!
Mains voltage!
– The device may only be operated indoors.
– The surrounding air may not carry any electrically con-
ductive dust.
– Maximum relative humidity 80% for temperatures up
to 31°C, linearly decreasing down to 50% relative
humidity at 40°C.
n The room temperature has to stay between 5 - 40°C.
n Altitudes up to 2000 m
n Degree of pollution 2 according to IEC 664.
4.5 Electrical connection
Before establishing the connection, compare the voltage and current
values stated on the type plate with the values of the power supply
system to be used.
Installation
- 18 -