FRITSCH PULVERISETTE 13 classic line - Manual (Page 4)

Table of contents
1 Basic structure............................................................................... 6
2 Safety information and use........................................................... 7
2.1 Requirements for the user..................................................... 7
2.2 Scope of application............................................................... 7
2.2.1 Operating principle............................................................. 8
2.2.2 Drive motor......................................................................... 8
2.3 Obligations of the operator................................................... 8
2.4 Information on hazards and symbols used in this manual.... 9
2.5 Device safety information.................................................... 12
2.6 Protective equipment.......................................................... 13
2.7 Hazardous points................................................................. 14
2.8 Electrical safety.................................................................... 14
2.8.1 General information......................................................... 14
2.8.2 Protection against restart................................................. 14
2.8.3 Overload protection.......................................................... 14
3 Technical data.............................................................................. 15
3.1 Dimensions.......................................................................... 15
3.2 Weight.................................................................................. 15
3.3 Operating noise.................................................................... 15
3.4 Voltage................................................................................. 15
3.5 Current consumption........................................................... 15
3.6 Power consumption............................................................. 15
3.7 Speed................................................................................... 15
3.8 Electrical fuses..................................................................... 16
3.9 Material................................................................................ 16
3.10 Final fineness..................................................................... 16
4 Installation................................................................................... 17
4.1 Transport............................................................................. 17
4.2 Unpacking............................................................................ 17
4.3 Setting up............................................................................. 17
4.4 Ambient conditions.............................................................. 18
4.5 Electrical connection............................................................ 18
4.5.1 Adapting to the mains....................................................... 19
5 Initial start-up.............................................................................. 20
5.1 Switching on......................................................................... 20
5.2 Switching off........................................................................ 20
6 Using the device........................................................................... 21
6.1 Setting the minimum gap width.......................................... 22
6.2 Setting the gap width........................................................... 23
6.3 Grinding with grinding disks of zirconium oxide.................. 24
Table of contents
- 4 -