FRITSCH LABORETTE 24 with V-shaped channel - Manual (Page 3)

Table of contents
1 Basic set-up.................................................................................... 5
2 Safety information and use........................................................... 6
2.1 Requirements for the user..................................................... 6
2.2 Intended use.......................................................................... 6
2.2.1 Operating principle............................................................. 7
2.3 Obligations of the operator................................................... 7
2.4 Information on hazards and symbols used in this manual.... 8
2.5 Device safety information.................................................... 11
2.6 Hazardous points................................................................. 12
2.7 Electrical safety.................................................................... 13
3 Technical data.............................................................................. 14
3.1 Dimensions .......................................................................... 14
3.2 Weight.................................................................................. 14
3.3 Voltage................................................................................. 14
3.4 Electrical fuses..................................................................... 14
3.5 Power consumption............................................................. 14
3.6 Vibration frequency............................................................. 14
3.7 Sample material / feed rate................................................. 15
3.8 Emissions............................................................................. 15
4 Installation................................................................................... 16
4.1 Transport ............................................................................. 16
4.2 Unpacking............................................................................ 16
4.3 Set-up................................................................................... 16
4.4 Ambient conditions.............................................................. 17
4.5 Electrical connection............................................................ 17
4.5.1 Mains connection.............................................................. 18
4.5.2 Control box / feeder connection....................................... 18
4.5.3 External interface connection........................................... 18
4.6 Initial start-up...................................................................... 19
5 Working with the LABORETTE 24................................................ 20
5.1 Operation............................................................................. 21
5.1.1 Switching on / off.............................................................. 21
5.1.2 Feed rate........................................................................... 21
5.1.3 Timer function................................................................... 21
5.1.4 Start / Interrupt / Stop / Reset.......................................... 22
5.1.5 Setting the layer height..................................................... 22
5.2 Conveying material.............................................................. 22
5.3 Conveying with the U-channel (standard)........................... 23
5.4 Conveying with the V-channel............................................. 23
5.5 Set-up mode......................................................................... 23
Table of contents
- 3 -