Hangar 9 Pulse XT 60 ARF - Manual (Page 27)

27
 Step 9
Slide the throttle pushrod into the pushrod tube on the
same side of the fuselage as the carburetor arm.
 Step 10a
Slide the pushrod through the connector on the carburetor
arm as shown. Do not tighten the screw at this time.
 Step 10b
Slide the connector (and carburetor arm) onto the
throttle pushrod. Re-attach the carburetor arm to the
engine, making sure it is position to operate the
carburetor properly.
Note: The final setup of the throttle
will take place later in the manual.
 Step 11
Pass a hook and loop strap through the slots in the
fuselage as shown.
Section 4: Glow Engine and Cowling Installation