Hangar 9 Pulse XT 60 ARF - Manual (Page 29)

29
 Step 16
Plug the throttle servo into the receiver. Center the throttle
stick and trim at the transmitter. With the throttle servo
centered, install the servo horn as shown in the photo.
 Step 17
Install the throttle servo in the fuselage using the hardware
provided with the servo. The output of the servo will be
oriented toward the pushrod wire.
 Step 18
With the throttle stick and trim centered, open the
carburetor to the mid-throttle position. Tighten the screw
that secures the pushrod wire at the carburetor.
 Step 19
Use the travel volumes in the transmitter to make sure
you are achieving full throttle and not over throwing and
binding the servo.
Section 4: Glow Engine and Cowling Installation